West Virginia
Programming Your HD Picture Settings
|
Problem
|
Possible Solution
|
|
No sound
|
- Press MUTE on the remote control to restore the volume level.
- Check that the receiver is set to the proper input source.
- Turn your VCR on.
|
|
No picture
|
- Check to be sure that all cables are connected properly and that your TV is tuned
to cable channel 3 or 4, if using the TO TV-VCR connections. Hand-tighten the cable
connections if necessary.
- Check that your component connection cables are not crossed. Y goes to Y, Pb to
Pb and Pr to Pr.
- If connected through the RCA Cable TV connection, make sure the cables are connected
properly.
- Turn VCR on.
- Ensure that the proper Cable TV display format for your TV has been selected.
|
|
No Guide or wrong Guide
|
- Check that your HD receiver is connected directly to the cable wall outlet.
|
|
Picture or sound is noisy on one channel
|
- Reconnect the coax cables and hand-tighten if loose.
|
|
Sound from only one stereo speaker
|
- Hand-tighten or reconnect the cables.
- Ensure that wires are not frayed and plugs are not bent or broken.
|
|
No power
|
- Reconnect the power cord.
- Ensure that the HD receiver is plugged into an active outlet.
|
|
Remote control does not work
|
- Press CABLE on the remote control.
- Ensure that nothing is blocking a clear line of sight between the HD receiver and
the remote control.
- Change the batteries in your remote control and then re-program your remote control.
|
|
Poor audio quality
|
- Use the remote control to set the relative to HD receiver volume level to approximately
3/4 of maximum volume level and then adjust the audio levels on the external devices.
|